Taarup Hay Machinery - Horizontal Mixers

Featues

• Ability to chop and mix complete small and large square bales along with round bales of hay and silage into a chopped ration.
• Designed to handle almost any bale type and size.
• The three point fully independent weighing system guarantees the accuracy, which is needed for successful diet feeding.
• Discharge ability available for both left and right side.
• Extremely wide conveyor running on (ultra glide) strips provides the benefit of attaining higher conveyor speed.
• Two contra rotating augers fitted with replaceable circular cutting blades with a multiple of usable cutting edges.
• All chains and sprockets are located in an oil bath, providing continuos lubrication when in use.
• The auger drive shafts rotate in special maintenance free ULTRA GLIDE bearings.
• The lower mixing chamber and auger troughs are lined with ULTRA GLIDE

• A special low friction HDPE plastic material, thus reducing power requirements.
• As an additional protection against corrosion the lower mixing chamber and auger troughs are constructed from special (cor-ten) copper impregnated alloy steel that is highly resistant to corrosion.
• Auger reversing tool supplied standard.
• All mixer controls are via electronic control panel, mounted in tractor cab.
• Rear loading door for additives is standard.
• Wide angle PTO shaft with shear bolt
• Hydraulic parking jack.
• Steel ladder.